Currently, users who use turn-milling machines are turning and milling machines. For example, annual sales of automotive milling machines are gradually increasing at a rate of about 20%. However, what should be paid attention to when using an automotive milling compound lathe? The following are the precautions when using the lathe for your reference in future operation and use.

When using a turn-milling compound machine, you must first understand the use and operation instructions of the lathe. It is best to read the instructions of ordinary lathes to understand the installation, maintenance and replacement of lathes. Secondly, ordinary lathes should be installed according to regulations.

So, during installation, we have to figure out which side is on top and which side is on the bottom. Finally, in order to protect the surface of the turning-milling compound lathe, it is best not to scratch the surface of the lathe with hard objects, so as not to damage the appearance of the lathe and cause unstable performance. At the same time, the surface of the turning and milling compound lathe should be cleaned frequently to keep it in a relatively hygienic state to prolong the service life of the lathe.

How to maintain the turning and milling machine.

Regularly wipe the anti-rust oil: key parts of the machine such as sliding carriages and spindle boxes.

2. Regularly check whether the screw parts are loose: the long-term use of the machine may lead to the loosening of small parts such as screws and protective covers. Please pay attention to check and deal with it in time;

3. Whether the environment is humid and dusty; the machine has electrical parts, and the environment is too humid or dusty will cause short circuit leakage;

4. Regularly check and replace hydraulic oil: regularly check whether there is a large amount of impurities or discoloration in the hydraulic oil, generally replace the hydraulic oil once every 10 months;

5. If you find abnormal noise or excessive vibration of the machine, you should contact our company immediately:

6. Make sure that enough lubricating oil is added before work, and the lubricating oil circuit works normally: abnormal lubrication causes important parts to heat up or even damage;

7. Small problems should be dealt with in time and cannot work while sick, otherwise it will seriously affect the service life of the machine;